2007 JD 956 Moco
The entire cutter-bar was dis-assembled and each piece was triple rinsed/washed and blown out with compressed air to ensure no contaminants.
EVERY single BEARING and SEAL in the entire CUTTER BAR is BRAND NEW!
-All 16 Spherical bearings on drive gears are new
-Multiple new drive gears, all inspected and cleaned
-All Quill-hub tapered roller bearings are new and tight
-Several hubs replaced with new
-All shear hubs in excellent shape, several are new
-All seals between cutter bar modules are new
-All O-rings on Quill hub and Idler gear plugs are new
-All parts were torqued to spec by John Deere manual
-Multiple new shear hub bolts
-All necessary parts were loctited according to manual spec
-The Cutter-bar was filled with 9.5L of Brand New John Deere Hy-Gaurd Gearoil
-The Cutter bar was painted with John Deere paint to protect it
-All knives and their bolts and nuts are Brand New
-The two small hydraulic hoses for the steer ram were replaced with New
-One of the gearboxes on the unit is also New
-The unit was timed according to the John Deere manual, all markings are in the correct position if you ever need to change a shear hub
-To top it all off, both back tires were replaced with BRAND NEW RUBBER
This 956 Moco was hooked-up to the Fendt 720 and run after coming out of the shop for 10 minutes. It ran smoothly and all timing is correct.
A brand new cutter bar is worth about $15,000 so consider that in shopping for a used unit, this unit is all but a new machine and should serve someone well for many years.
The steel on steel conditioners are hard to beat.